“FISCHER” CHEMICAL ANCHOR FIS P PLUS 300T

The calibrated thixotropy allows it to work well for both horizontal and vertical applications (the resin does not drip or run, allowing excellent bar adhesion).
The absence of styrene and the low content of volatile organic compounds (VOCs) allows it to be used indoors.
The resin can also be applied in wet holes: in this case, the load application time must be doubled (FIS P PLUS 410 C also in water-filled holes from M12).
The hybridising agents contained in the FIS P PLUS chemical anchor allow high load levels to be maintained over the temperature range of -40 °C to +80 °C.
Thanks to minimal initial bleeding, minimal wastage is guaranteed. Resin properly mixed through the FIS MR PLUS mixer takes on a homogenous grey colour.
The FIS P PLUS 300 T chemical anchor cartridge is immediately ready for use. There is no bag to remove and/or cut, but simply screw in the FIS MR PLUS mixer.
FIS P PLUS is a resin certified for use in masonry and non-cracked concrete.