“ZYROBOND” METACRYLATE ADHESIVE 2K-MMA 7295

Reinforced, structural two-component adhesive system for bonding a wide variety of
of metals and precious metals, thermoplastics, acrylics, wood, ceramics, stone, et
Areas of application:
Electronic and electrical components, engine components, automotive building
housing, sports equipment, signage, displays, motorbike fairings.
Application examples:
► Repair of fibreglass such as mirrors, bumpers, front grills, lamp housing, spoilers, boots and roof
modules on motor vehicles.
► Repair of cabin parts and containers. ► Plastic fabrication. ► Signs and displays.
► Advertising and decoration. ► Surface treatment for bumps, dents and scratches.
Working time: 5-7 min ● Workable after: 1-3 hours ● Final hardening: 24 hours
Bonding joint thickness: 0.5 – 5.0 mm ● max. Elongation: >7% ● Temperature resistance: -40°C to +120°C

Instructions for use: The surface must be clean, dry and free of contaminants such as oil or grease. Surfaces that
are lightly sanded before gluing are particularly suitable for this product. Components A and B must be mixed
in equal proportions. The 2 components must be mixed thoroughly to ensure optimal adhesion. MMA 7306-S can
be applied immediately with a static mixer to the surface to be bonded. To be sure that the mixing ratio is 100%.
accurate, it is useful to squeeze out and discard a small portion of adhesive. Excess adhesive can be removed with
organic solvents. The bonded joint should only be loaded after final polymerisation to ensure a complete bond.
Caution: mixing large volumes causes an exothermic reaction. Heat and smoke are created.